Roof Inspection Criteria

The roof cannot have more than three layers of roofing.

Roof inspection criteria.

Home roof inspections should be done by. Visual examination from the ground with binoculars. Thoroughly training and certifying capable roof inspectors and roof contractors to use its patent pending process to perform inspections to determine if a roof qualifies for a leakfree roof certification. If the inspection reveals the need for roof repairs and the.

First part 1926 subpart m does not require fall protection for those conducting the initial inspection of the roof to determine what work needs to be done. Missing or broken shingles. This is for your own safety as a home inspector roofs can be steeply sloped and slippery especially when wet. Nailing or progress inspection where the existing roofing material is being completely removed and replaced and the underlying sheathing is being replaced or added over skip sheathing a nailing inspection is required prior to any roofing materials being placed.

The appraiser must inspect the attic for evidence of possible roof problems. Proactively and reactively connecting the real estate community with nrcia certified roof inspectors and contractors. That roofing materials on the undamaged part of the roof are correctly installed and not defective so the issue isn t with installation or materials. Cracked caulk or rust spots on flashing.

Cracked and worn rubber boots around vent pipes. What a roofer should document for you. Any obvious damage should be repaired immediately. 1 floating roof ifr and efr inspections shall be conducted by visually inspecting the floating roof deck deck fittings and rim seals from within the storage vessel.

Shingles that are buckling curling or blistering. This is where an inspection from a roofing contractor that you are paying is essential. Here s a roofing inspection checklist. Any of the conditions described in paragraphs d 1 i through d 1 v of this section constitutes inspection failure.

This subpart sets forth requirements and criteria for fall protection in construction workplaces covered under 29 cfr part 1926. 1 visible damage and debris the first step to inspecting a roof is looking for obvious signs of damage including visible structural deformations dirt and debris standing water and blocked or broken gutters and downspouts. Possible missing or loose roofing materials overall condition of roofing materials ridges caps and drip edges soundness of drains downspouts and gutters flashing around roof pipes chimneys vents valleys and. Missing or damaged chimney cap.

Ok that s technically not part of your roof but since. Prior to installing roof coverings on all roofs having a slope of 2 12 or less.